User Guide

24 NetWare Migration Wizard 6 Aministration Guide
NetWare Migration Wizard 6 Aministration Guide
103-000161-001
August 29, 2001
Novell Confidential
Manual Rev 99a38 July 17, 2001
 During the installation, create volumes on the destination server that are
the same size as, or larger than, volumes on the source server.
Volume names on the destination server must be the same as the volume
names on the source server.
Migration Wizard migrates compressed volumes. If you are migrating
compressed volumes to uncompressed volumes, Migration Wizard
decompresses the volumes during the migration. Make sure you have
enough room on the uncompressed volume to accommodate the source
volumes once they are decompressed.
 If migrating from NetWare 4, install and configure the IPX protocol.
The IPX protocol must be bound to the destination server for the
migration to work. (You can remove IPX after completing the migration.)
IMPORTANT: IP addresses for the source server will not be migrated. For more
information on changing your IP addresses, see Step 3 on page 28.
 Install the destination server with the NetWare operating system that you
are migrating to.
 For instructions on installing NetWare 5, see the NetWare 5
Overview and Installation Guide (http://www.novell.com/
documentation/lg/nw5/docui/index.html).
Make sure that you select the New Server option on the Additional
Products and Services screen during the NetWare 5 installation, and
deselect all products except SMS.
 For instructions on installing NetWare 5.1, see the NetWare 5.1
Installation Guide (http://www.novell.com/documentation/lg/nw51/
docui/index.html).
Make sure that you select the custom option on the Installation
Options screen during the NetWare 5.1 installation, and deselect all
deselectable products except SMS. Don’t worry about any default
products that you can’t deselect.
 For instructions on installing NetWare 6, see the "NetWare 6
Overview and Installation Guide".
Make sure that you select the Pre-migration server option during the
NetWare 6 installation. And then select the custom option so that you
can verify that you have enough room on your destination server to
accomodate your source server data.
Continue with the next section, "Run Migration Wizard."