Technical data

64
Chapter 5: Operation
Stacker Modes
The stacker operates in four modes:
• normal
• density select (not used with Silicon Graphics systems, where it is controlled by the
host)
• SCSI ID select
SCSI ID select mode is described in “Setting the Stacker’s SCSI ID” in Chapter 4.
• code update
Updating stacker firmware is described in “Updating Firmware on the DLT2500XT
Stacker” in Chapter 6.
The current mode is displayed in the window in the control panel. Press the Display Mode
button to change modes.
• In normal mode, pressing and releasing the Display Mode button puts the stacker in
density select mode.
• In normal mode, holding the Display Mode button five seconds puts the stacker in
SCSI ID select mode.
• In SCSI ID or density select mode, pressing and releasing the Display Mode button
returns the stacker to normal mode.