User guide

Installation
5. Slide the drive into the bay as far as it will go. Make sure the ejector
levers are in the fully open position to ensure a correct latch while
installing.
Figure 2-8. Sliding the drive tray into the RA4000
6. Close both latches against the front of the drive until they snap into
place 1 Levers on each latch should catch behind the metal lip of the
bay, drawing the drive into position and securing it in place 2.
1
2
Figure 2-9. Latching the drive into place
After installing the drive, pull it to see if the tray is properly seated. If you
are able to remove the drive without releasing the latches, open the latches all the way
and try again to seat the drive, ensuring that the levers engage the front panel and pull
the drive into position.