HP 3PAR OS 3.1.3 Command Line Interface Reference

statfcoe
DESCRIPTION
The statfcoe command displays statistics for Fibre Channel over Ethernet connections.
SYNTAX
statfcoe [options <arg>]
AUTHORITY
Any role in the system.
OPTIONS
-d <secs>
Specifies the looping delay in seconds <secs>. The default is 2.
-iter <number>
Specifies that the command execution should terminate after a user-defined <number> of iterations.
-nodes <nodelist>
Specifies the list of nodes for which the ports are included.
-slots <slotlist>
Specifies the list of PCI slots for which the ports are included.
-ports <portlist>
Specifies the list of ports which are included. Lists are specified in a comma-separated manner
such as: -ports 1,2 or -ports 1.
-counts
Shows the counts. The default is to show counts/sec.
-fullcounts
Shows the values for the full list of counters instead of the default packets and KBytes for the specified
protocols. The values are shown in three columns:
Current - Shows counts since the last sample.
CmdStart - Shows counts since the start of the command.
Begin - Shows counts since the port was reset.
-prev
Shows the differences between the current and previous samples.
-begin
Shows the values from when the system was last initiated.
SPECIFIERS
None
RESTRICTIONS
None
statfcoe 603