HP 3PAR OS 3.1.3 Command Line Interface Reference

statld
DESCRIPTION
The statld command displays read/write (I/O) statistics about Logical Disks (LDs) in a timed
loop.
SYNTAX
statld [options <arg>] [<LD_name|pattern>...]
AUTHORITY
Any role in the system.
OPTIONS
-vv {<VV_name|pattern>}...
Show only LDs that are mapped to Virtual Volumes (VVs) with names matching any of names or
patterns specified. Multiple volumes or patterns can be repeated using a comma-separated list (for
example -vv <VV_name>,<VV_name>...).
-domain {<domain_name|pattern>}...
Shows only LDs that are in domains with names matching any of the names or specified patterns.
Multiple domain names or patterns can be repeated using a comma-separated list (for example
-domain <domain_name>,<domain_name>...).
–rw
Specifies that reads and writes are displayed separately. If this option is not used, then the total
of reads plus writes is displayed.
–d <sec>
Specifies the interval, in seconds, that statistics are sampled using an integer from 1 through
2147483. If no interval is specified, the option defaults to an interval of two seconds.
–iter <number>
Specifies that I/O statistics are displayed a specified number of times as indicated by the number
argument using an integer from 1 through 2147483647.
–begin
Specifies that I/O averages are computed from the system start time. If not specified, the average
is computed since the first iteration of the command.
–idlep
Specifies the percent of idle columns in the output.
–sortcol <col> [,<dir>][:<col>[,<dir>]...]
Sorts command output based on the column number <col>. Columns are numbered from left to
right, beginning with 0. You must specify a column number. In addition, you can specify the
direction of sorting <dir> as follows:
inc
Sort in increasing order (default).
dec
Sort in decreasing order.
Multiple columns can be specified separated by a colon (:), Rows with have the same information
in them as earlier columns will be sorted by the values in the later columns.
–filt <fspec>
statld 609