HP VPN Firewall Appliances Network Management Configuration Guide

129
You must enable the PPPoE protocol on the PPPoE server, configure the PPPoE username and
password, and assign an IP address to the peer of the PPP connection. (Details not shown.)
Verifying the configuration
1. View the summary about PPPoE client sessions on the PPPoE client:
a. Select Network > PPPoE > Session from the navigation tree.
b. Select Summary Information from the Information Type list.
Figure 69 sho
ws that the status of the PPPoE client session is
PPPUP .This indicates that PPP
negotiation is complete.
Figure 69 PPPoE session summary
2. View information about the dialer interface on the PPPoE client:
Select Device Management > Interface from the navigation tree or select Network > PPPoE >
Client.
Figure 70 shows that interface Dialer 1 already gets an IP address assigned by the PPPoE server.
Figure 70 Dialer interface information
Configuring a PPPoE client at the CLI
PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.