HP VPN Firewall Appliances Network Management Configuration Guide

435
Task Remarks
Configuring IS-IS
routing information
control
Configuring IS-IS link cost Optional
Specifying a preference for IS-IS Required
Configuring the maximum number of ECMP routes Optional
Configuring IS-IS route summarization Optional
Advertising a default route Optional
Configuring IS-IS route redistribution Optional
Configuring IS-IS route filtering Optional
Configuring IS-IS route leaking Optional
Configuring a DIS
priority for an
interface
Specifying intervals for sending IS-IS hello and CSNP packets Optional
Specifying the IS-IS hello multiplier Optional
Configuring a DIS priority for an interface Optional
Disabling an interface from sending/receiving IS-IS packets Optional
Disabling hello source address check for a PPP interface Optional
Enabling an interface to send small hello packets Optional
Configuring LSP parameters Optional
Configuring SPF parameters Optional
Configuring convergence priorities for specific routes Optional
Setting the LSDB overload bit Optional
Configuring system ID to host name mappings Optional
Enabling the logging of neighbor state changes Optional
Enhancing IS-IS
network security
Configuring neighbor relationship authentication Optional
Configuring area authentication Optional
Configuring routing domain authentication Optional
Enabling IS-IS SNMP trap Optional
Binding an IS-IS process with MIBs Optional
Configuring basic IS-IS
This section describes the basic settings required for an IS-IS network to run.
Configuration prerequisites
Before the configuration, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for all interfaces to ensure IP connectivity between neighboring nodes.