HP VPN Firewall Appliances Network Management Configuration Guide

750
Displaying and maintaining IPv6 static routes
Task Command Remarks
Display IPv6 static route
information.
display ipv6 routing-table protocol static [ inactive |
verbose ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
IPv6 static routing configuration example
Network requirements
As shown in Figure 389, configure IPv6 static routes so that hosts can reach one another.
Figure 389 Network diagram
Configuration procedure
1. Configure IPv6 addresses for all interfaces. (Details not shown.)
2. Configure IPv6 static routes:
# Enable IPv6 and configure the IPv6 default route on Router A.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ipv6 route-static :: 0 4::2
# Enable IPv6 and configure two IPv6 static routes on Firewall.
<Firewall> system-view
[Firewall] ipv6
[Firewall] ipv6 route-static 1:: 64 4::1
[Firewall] ipv6 route-static 3:: 64 5::1
# Enable IPv6 and configure the IPv6 default route on Router B.
<Router B> system-view
[Router B] ipv6