HP VPN Firewall Appliances Network Management Configuration Guide

756
Ste
p
Command Remarks
3. Configure a filter policy
to filter incoming routes.
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } import
By default, RIPng does not filter
incoming routing information.
4. Configure a filter policy
to filter outgoing routes.
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ protocol
[ process-id ] ]
By default, RIPng does not filter
outgoing routing information.
Configuring a priority for RIPng
Routing protocols have their own protocol priorities used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value, the higher the priority.
To configure a RIPng priority:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a RIPng priority.
preference [ route-policy
route-policy-name ] preference
Optional.
By default, the RIPng priority is 100.
Configuring RIPng route redistribution
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a default routing
metric for redistributed routes.
default cost cost
Optional.
The default metric of redistributed
routes is 0.
4. Redistribute routes from
another routing protocol.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
No route redistribution is
configured by default.
Tuning and optimizing the RIPng network
This section describes how to tune and optimize the performance of the RIPng network, as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
• Configure a network layer address for each interface.
• Configure the basic RIPng functions.