HP Remote Graphics Software 5.4.0 User Guide

3.2.4.2 Uninstalling the Sender on Linux
To uninstall the RGS Sender on Linux, perform the following steps:
1.
Log in as root.
2.
If the default install.sh was used, then the following command should report some variation of the
following packages:
# rpm -qa | grep -i rgsender
rgsender_linux_64-5.1.0-1
rgsender_config_64-5.1.0-1
3.
To remove the rgsender package (and corresponding configuration rpm if used), execute the
command:
rpm -e --allmatches rgsender_linux_64 rgsender_config_64
4.
If the rgsender_config_64-*.rpm was installed, it must be removed first (or together as
demonstrated above) before removing the rgsender_linux_64-*.rpm package. This resolves
dependencies between the packages, and undoes the previous customizations performed by this
rpm. If you are upgrading your system from a previous version of RGS, it is suggested that you
remove both packages, and then apply the new software rpms for supported results.
76 Chapter 3 Installing RGS ENWW