HP Scripting Tools for Windows PowerShell User Guide: OA cmdlets

Table 1 HP OA Cmdlets for Windows PowerShell (continued)
DescriptionCmdlet
Enables or disables the OA to provide IP addresses to the devices in the
bays using DHCP. This cmdlet also modifies EBIPA settings for bay device(s).
Set-HPOAEBIPA
Sets the Enclosure details.Set-HPOAEnclosure
Enables or disables OA support required to allow peer-to-peer network
communication necessary for iLO Federation.
Set-HPOAEnclosureiLOFederationSupport
Enables or disables Enclosure IP Mode.Set-HPOAEnclosureIPMode
Restores the OA to its factory defaults.Set-HPOAFactoryDefault
Enables or disables enclosure firmware management and configures the
firmware management settings.
Set-HPOAFWManagement
Sets the network default gateway.Set-HPOAGateway
Enables or disables the HP SIM SSO mode.Set-HPOAHPSIMTrustMode
Enables or disables HTTPS access to the OA.Set-HPOAHTTPS
Configures IP settings for the OA to DHCP or Static mode.Set-HPOAIPConfig
Enables or disables IPv6 protocol for management interfaces of all devices
in the enclosure.
Set-HPOAIPv6
Enables or disables dynamic DNS using IPv6 for either the specified bay
or the active or standby OA.
Set-HPOAIPv6DynamicDNS
Enables or disables directory authentication.Set-HPOALDAP
Sets the LDAP settings.Set-HPOALDAPSetting
Enables or disables Link Loss Failover for OA Redundancy and modifies the
LLF interval.
Set-HPOALLF
Sets a minimum length for passwords.Set-HPOAMinimumPasswordLength
Sets the OA name.Set-HPOAName
Configures the external NIC for Auto-negotiation or forced link settings.Set-HPOANIC
Enables or disables NTP support for the OA. This cmdlet also sets the polling
interval of the NTP servers and the primary and secondary servers for
synchronizing time and date using the NTP.
Set-HPOANTP
Sets the password of the user that executed the command.Set-HPOAPassword
Sets the power on the specified bay device.Set-HPOAPower
Set the PowerDelay status for the specified server or range of servers or for
specified interconnect or range of interconnects.
Set-HPOAPowerDelay
Configures power settings (NotRedundant, Redundant, and PowerSupply).Set-HPOAPowerSetting
Sets the rack name.Set-HPOARackName
Registers or unregisters the OA with the Insight Remote Support/aggregator.Set-HPOARemoteSupport
Sets the IP port number and IP address (or DNS name) for remote system
log.
Set-HPOARemoteSyslog
Enables or disables auto-configuration of IPv6 addresses from Router
Advertisement messages for management interfaces of all devices in the
enclosure.
Set-HPOARouterAdvertisement
Enables or disables SSH support for the OA.Set-HPOASecureSh
Sets the boot device on the next boot or on permanent boot order.Set-HPOAServerBootOrder
11