HP Scripting Tools for Windows PowerShell User Guide: OA cmdlets

Table 1 HP OA Cmdlets for Windows PowerShell (continued)
DescriptionCmdlet
Sets the number of minutes before inactive sessions are removed.Set-HPOASessionTimeout
Enables or disables the auto-configuration of IPv6 addresses from SLAAC
messages.
Set-HPOASLAAC
Enables or disables SNMP and modifies SNMP settings.Set-HPOASNMP
Enables or disables strong password requirements for user passwords.Set-HPOAStrongPassword
Enables or disables remote system logging.Set-HPOASysLogRemote
Enables or disables telnet access to the OA.Set-HPOATelnet
Sets the time zone.Set-HPOATimezone
Enables or disables IP security for the OA.Set-HPOATrustedHost
Sets the UID on or off for the Onboard Administrator, interconnect, server
or enclosure.
Set-HPOAUID
Allows the OA to select which USB controller to enable.Set-HPOAUSB
Enables or disables a user account that was previously disabled by the
Disable-HPOAUser command and modifies user access level and other user
information.
Set-HPOAUser
Enables or disables VLAN on the enclosure.Set-HPOAVLAN
Enables or disables XML reply data over an HTTP connection.Set-HPOAXMLReply
Downloads the specified type of trusted certificate (CA, OA, HPSIM, LDAP,
User).
Start-HPOACertificateDownload
Downloads a previously saved configuration script file from a specific IP
host, and then executes it.
Start-HPOAConfigDownload
Starts manual firmware discovery.Start-HPOAFirmwareServerDiscovery
Generates new private keys associated with the OA SSH service and/or
SSL web services.
Start-HPOAKeyGeneration
Downloads an authorized key file to use for SSH logins.Start-HPOASSHKeyDownload
Uploads support dump data to the specified URL.Start-HPOASupportDumpUpload
Uploads the extended system log history for the current OA.Start-HPOASyslogUpload
Forces the redundant OA to become the active OA.Switch-HPOA
Sends a test message to the configured email address.Test-HPOAAlertMail
Checks if the SSH connection to the OA is currently valid or expired.Test-HPOAConnection
Run LDAP tests and optionally attempt to login to the LDAP server using the
username and password.
Test-HPOALDAP
Sends a test SNMP trap to all of the configured trap destinations.Test-HPOASNMP
Tests the remote system log settings by logging a test message to the syslog.Test-HPOASyslog
Update OA firmware by multi methods.Update-HPOAFirmware
Initiates manual update of the selected servers using the configured HP
firmware ISO image URL.
Update-HPOAFWServer
Downloads a new flash image from the network and uses it to update the
firmware for iLO.
Update-HPOAiLO
Checks if an updated version of the OA cmdlets is available on
Hewlett-Packard website and returns the link to download this new version.
Update-HPOAModuleVersion
12 HP Scripting Tools for Windows PowerShell cmdlets