Using the HP DTC Manager/UX

Installing DTC Manager/UX with HP-UX 10.x

Note Quotation marks are mandatory if you are declaring more than one device and a space

is not allowed after the equal (=) sign.

Caution Do not remove any existing LAN device declarations from this line. This information

might be needed for other system functions.

3 Save the file (if you made any modifications) and exit the editor.

Running the daemons without rebooting

DTC Manager/UX cannot run without the required daemon processes.

Note The netdaemons configuration file must contain the values described in the

previous section before you can start the daemons without rebooting your system.

Normally, the daemons are started automatically each time you boot your system. If

you do not want to reboot your system at this time you can start the daemons

manually by following the steps below:

1 If the required daemons are not already running on your system, start them by

entering:

/sbin/init.d/rbootd start

to start the rbootd daemon.

2 Enter:

/sbin/init.d/dtcmgr start

to start the dtcnmd and dtcnmp daemons.

Proceed to the next section to verify that the daemons are running.