Using the HP DTC Manager/UX

Checking the terminal connections

Follow these steps for each terminal connected to the DTC.

1 Press Return. The DTC prompt, usually DTC>, should appear. Enter the

connect command with the IP address

of the system you want to connect to.

DTC> connect 15.13.12.12

Connection #1 established to mysystem.mygroup.mycorp

To return to DTC interface, type <CTRL>K

2 If you are not successful, try to modify the configuration of the DTC (refer to

chapter 6). If the DTC does not respond, it probably means that the DTC LAN

address is not correct. Delete the DTC and then add it again.

3 If you still cannot establish a connection, go to the troubleshooting section in

chapter 15.

Configuration parameter definitions

DTC Name Enter a name consisting of up to 8 alphanumeric characters. You can include

hyphens (-) and underscores (_) but the ﬁrst character must be alphabetic. The DTC

name ﬁeld must not be left blank.

The DTC name is a unique name used by the DTC manager to identify a particular

DTC. For simplicity, the DTC name and the nodename portion of the DTC node

name are often the same name. However, they are used for separate tasks by the

DTC Manager/UX and the system.

1 You can only use a system name here if you have conﬁgured the system name in the DNS server.