DisplayMaker Legacy ColorMark+ - User Guide

ColorSpan Workflow 3-3
ColorSpan Workflow Once you have created a ColorSpan (.CX) profile, you can begin
using it immediately on the server on which it was created.
ColorMark profiles can also be copied between ColorSpan serv-
ers that are running the same version of the ColorMark+ soft-
ware. ColorSpan profiles do not use any files on the client
workstations.
Selecting a
ColorMark Profile
The profile you specify determines the color and calibration
data applied to each document. Documents sent as unseparated
jobs are color corrected by the ColorMark Color Management
System, using the color and calibration data in the profile. Doc-
uments sent as separated jobs are adjusted using the calibration
data in the profile, but no color correction is applied, since an
ICC profile was applied at the client workstation.
You can view, and in some cases select, a ColorMark profile at
the following points in the System Control interface:
◆ At the Port Configuration dialog box, all incoming print jobs
use the profile specified in this dialog box
◆ From the Document Details dialog box, accessible from an
Input or Output queue (including the Attention queues), you
can change the profile applied to the job. If you change the
profile from an Output queue, the new profile is applied
without re-RIPing the job.
Fig. 3-1. Selecting a profile (Port Configuration shown)
Click a profile listing to select it