- Silex Technology Embedded Intelligent Module Developer's Reference Guide

Advanced Configuration

Silex

Page 51

Part Number 140-00192-100

Table 21 GPIO General Commands

Command

Description

SET GPIO DIR [IN|OUT] <gpio-num>

GPIO # = {1|2|3|4|5|6|7|8}

Sets GPIO signal to be an input or an output. The setting

only takes effect if the GPIO signal is not selected for

special function operation. <gpio-num> must be in the

range 1-8.

NOTE: The direction bit configuration is not changed by a

configuration reset to default.

SHOW GPIO DIR

Shows current setting of the GPIO direction configuration.

Example:

Local> show gpio dir

GPIO Direction

--------------

1 [OUT]

2 [IN]

3 [IN]

4 [IN]

5 [SPCL]

6 [SPCL]

7 [SPCL]

8 [SPCL]

Local> set gpio dir in 1

Local> set gpio dir out 2