User guide

506 Chapter 20 Editing MIDI Events in the Transform Window
 Rel.Cres: This only works if the Inside Position selection condition is selected. The
effect is similar to that achieved by Crescendo, but the previous values of the
parameters being altered are taken into account when the crescendo is created,
preserving the relative feel of the original.
 Use Map: The set map will be used when this operation is selected (see below).
To set the values for an operation:
m Use the mouse as a slider, or directly type the desired value into the field.
Using the Map
128 vertical bars reflect the full MIDI value range (from 0 to 127), and provide a visual
overview of the transformation.
Essentially, each bar represents a particular MIDI value—which can be mapped to a
different value. The type of event, and operations, are determined in the Selection
Conditions and Operations areas.
To give you an example that may help your understanding:
 Each of the bars could represent a MIDI note number (from 0 to 127) value.
 By default, there is a 1:1 relationship for each bar, where value 1 = value 1, value 15 =
value 15, and so on, throughout the 128 bars. Applying this to MIDI note numbers,
bar 60 = C3 (middle C), bar 61 would represent C#3, bar 62 = D3, and so on.
The default and mapped values are shown in the two fields to the lower-left of the
map graphic.
 You can alter these values directly in the fields, or by dragging any of the bars
vertically. As you do so (using either method), the corresponding field/bar is updated.
 If you alter the bar 60 (middle C) value to show 72 in the “mapped to” field, this value
will be remapped accordingly when the transform operation is applied.
This will result in all MIDI note number 60 messages being transformed into MIDI note
number 72 messages (if you’re a mathematics whiz, you will have worked out that this
would effectively transpose all C3 notes to C4).