User`s guide
Table Of Contents
- Ascend Customer Service
- How to use this guide
- What you should know
- Documentation conventions
- How to use the on-board software
- Manual set
- Configuring WAN Connections
- Configuring IP Routing
- Introduction to IP routing on the Pipeline
- Managing the routing table
- Parameters that affect the routing table
- Static and dynamic routes
- Configuring static routes
- Specifying default routes on a per-user basis
- Enabling the Pipeline to use dynamic routing
- Route preferences
- Viewing the routing table
- Fields in the routing table
- Removing down routes to a host
- Identifying Temporary routes in the routing table
- Configuring IP routing connections
- Ascend Tunnel Management Protocol (ATMP)
- IP Address Management
- Connecting to a local IP network
- BOOTP Relay
- DHCP services
- Dial-in user DNS server assignments
- Local DNS host address table
- Network Address Translation (NAT) for a LAN
- Configuring IPX Routing
- How the Pipeline performs IPX routing
- Adding the Pipeline to the local IPX network
- Working with the RIP and SAP tables
- Configuring IPX routing connections
- Configuring the Pipeline as a Bridge
- Defining Filters and Firewalls
- Setting Up Pipeline Security
- Pipeline System Administration
- Pipeline 75 Voice Features
- IDSL Implementations
- APP Server utility
- About the APP Server utility
- APP Server installation and setup
- Configuring the Pipeline to use the APP server
- Using App Server with Axent SecureNet
- Creating banner text for the password prompt
- Installing and using the UNIX APP Server
- Installing and using the APP Server utility for DO...
- Installing and using the APP Server utility for Wi...
- Installing APP Server on a Macintosh
- Troubleshooting
- Upgrading system software
- What you need to upgrade system software
- Displaying the software load name
- The upgrade procedure
- Untitled
IP Address Management
BOOTP Relay
Pipeline User’s Guide Preliminary January 30, 1998 3-9
BOOTP Relay
The Bootstrap Protocol (BOOTP) defines how a computer on a TCP/IP network
can get its Internet Protocol (IP) address and other information it needs to start up
from another computer. The computer that requests startup information is called
the BOOTP client, and the computer that supplies the startup information is
called the BOOTP server. A request for startup information is called a BOOTP
request, and the BOOTP server’s response is called a BOOTP reply.
When the BOOTP client and BOOTP server are not on the same local-area
network, the BOOTP request must be relayed from one network to another. This
task, known as BOOTP relay, can be performed by a Pipeline.
A device that relays BOOTP requests to another network is known as a BOOTP
relay agent. In addition to delivering BOOTP requests to servers, a BOOTP relay
agent is responsible for delivering BOOTP replies to clients. In most cases, the
agent is a router that connects the networks, such as a Pipeline.
By default, a Pipeline does not relay BOOTP requests to other networks. To
enable the BOOTP relay feature for BOOTP clients connected to your Pipeline,
follow these steps:
1
Obtain the IP address of up to two BOOTP servers to be used.
2
Open the Ethernet > Mod Config:
20-A00 Mod Config
BOOTP Relay...
>BOOTP Relay Enable=No
Server=0.0.0.0
Server=0.0.0.0
3
Select BOOTP Relay Enable and set it to Yes.
4
Select Server and press Enter to open a text box. In the text box, enter the IP
address of the BOOTP server. Press Enter to close the text box.
5
If there is another BOOTP server available, select the second menu item
named Server and enter its IP address.
You are not required to specify a second BOOTP server.
Note:
If you specify two BOOTP servers, the Pipeline that relays the
BOOTP request determines when each server is used. The order of the