Instruction Manual

Page -30-© Audient Ltd
Record Enable Mode
Use record enable (20) within DAW control surface
mode when arming tracks for recording in Logic.
Activate this
mode and then
use the large
green channel
select switches
(18) to record
enable each track
active on the
eight channel
HUI
TM
bank.
Please note that by using multiple channel select switches (18),
you can record enable more than one track at once.
Automation Modes
The automation mode control (21) is used in the DAW
layer to set host specific automation modes like read,
touch and latch etc.
This control can be used to access automation modes for
channels active on the control surface or the eight dummy
channels provided at the start of your session that control
the ASP2802 analogue automation (see the automation
chapter starting on page 3).
The available automation modes in Logic are:
• Read
• Write
• Touch
• Latch
• Off
Control Surface Functions