Manual

Introduction
8
Alarm Input:
Alarm IN 1~16 are 16 CH alarm input interfaces. There are no type requirements
for sensors. NO type and NC type are both available.
The way to connect sensor and the device is as shown below:
The alarm input is an open/closed relay. If the input is not an open/closed
relay, please refer to the following connection diagram:
Alarm Output:
The way to connect alarm output device:
Pull out the green terminal blocks and loosen the screws in the alarm-out port.
Then insert the signal wires of the alarm output devices into the port of NO and
COM separately. Finally, tighten the screws. Provided that the external alarm
output devices need power supply, you can connect the power supply as per
the following figures.