Reference Guide

1864 View reference
Console view
Adjusting channel strip parameters
To adjust Console view controls
The Console view contains buttons, sliders, and knobs. Faders and knobs can be adjusted in
several ways:
• Click the center of a knob and drag up or down.
• Point to a control and scroll the mouse wheel.
• Double-click the center of a knob and type the desired value.
• Double-click the value display below a volume fader and type the desired value.
• Double-click the bottom of a knob to reset it to its snap-to position.
• To adjust the same control in all channel strips, hold down the CTRL key and adjust a control.
• To adjust the same control in all selected channel strips of the same type, hold down
CTRL+SHIFT and adjust a control in any selected channel strip.
Snap-to positions
Faders and knobs have snap-to positions. To set the snap-to position, move a control to the desired
snap-to position, right-click the control, and choose Value > Set Snap To = Current.
To arm a channel strip for automation writing
Click the channel strip’s Write Automation button.
To disable automation writing for the channel strip, click the Write Automation button again.
To arm a single control for automation writing
Right-click the control and choose Automation Write Enable on the pop-up menu.
To disable automation writing for the control, choose Automation Write Enable on the menu again.
Read Automation and Write Automation states
Read Automation and Write Automation buttons are fully colored when they affect the entire
channel strip. If only a subset of the channel strip’s controls are affected, the Read Automation
button and Write Automation buttons are only partially colored.
Tip: To adjust faders and knobs with greater precision, hold down the SHIFT key while adjusting the
control.
Tip: To disable automation writing for all write-enabled channel strips, click the Clear all
automation write enables
button in the Control Bar’s Mix module. For details, see “Mix
module”
on page 509.