Reference Guide

967
ProChannel (Producer only)
To remove a module
Right-click the module header and select Remove Module on the pop-up menu.
To replace a module
Right-click a module header or blank space in ProChannel and select Replace Module on the pop-
up menu.
To reorder a module
The signal flows from top to bottom. Click a module’s gripper and drag the module up/down to the
desired position.
Figure 285. Drag a module’s gripper up/down to reorder the signal chain.
To select a module
Click a module to make it the active module. The active module is shaded slightly. You can use ACT
to control parameters in the active module, and all context menu commands operate on the active
module when right-clicking an empty space in ProChannel.
To specify the default ProChannel configuration
1. Insert and arrange the ProChannel modules in the desired order.
2. Do one of the following:
• To specify the default configuration for tracks. Right-click any empty space in a track’s
ProChannel and select Set Modules as Default for Tracks on the pop-up menu.
• To specify the default configuration for tracks. Right-click any empty space in a bus’
ProChannel and select Set Modules as Default for Buses on the pop-up menu.
To route ProChannel pre-effects bin or post-effects bin
By default, the ProChannel signal is routed prior to the channel’s effects bin (pre). To route
ProChannel after the effects bin (post), right-click any empty space in ProChannel and select Post-
FX bin on the pop-up menu.