Manual Chapter 5

5-43
Machine Moves
One of the six screens shown on the previous page (side view) will be dis-
played when entering the Machine Move section. Each screen shows a sep-
arate solution to bring the equipment into alignment. Solutions are
expressed in mils or millimeters and show the direction the equipment
should be moved.
To select the screens, press the Left/Right Arrow to toggle through them.
Except for first reading sets, all the screens default back to the solution
arrangement they were in when last used. For first reading sets, the left
machine will normally be selected. However, when Motor or Move are on
the right side, they will be selected.
The target indicates how close the machine horizontal or vertical positions
are to being in tolerance. The center (bullseye) indicates an excellent range.
The middle ring represents an acceptable range. The outer ring represents
> 1 times and < 2 times the acceptable range. No ring highlighted indicates
> 2 times acceptable range.
Press the Enter key to proceed to the Horizontal Move screen.
Note
Even though it isn’t indicated on the Vertical Machine Moves
screen, it is possible to perform a live move in the vertical
direction. Refer to “Using Live Mode” on page 5-45 for details.