Technical data

PortServer Terminal Server Page 59
snmp
Syntax: snmp [run=off | on][auth_trap=off | on][trap_dest=ipaddress]
[location=PortServer’s location]
The snmp command is used to configure and enable/disable snmp. The snmp community is
“public.” Snmp sets are not supported.
snmp run=on|off
This starts or stops the SNMP daemon. Default is Off.
snmp auth_trap=on|off
This configures SNMP to send or ignore authentication traps when an authentication
error occurs. Default is Off.
snmp trap_dest=IP address
This configures SNMP to send all traps to the IP address given.
snmp location="location of PortServer"
This gives SNMP the value of system.sysLocation, which is a text string that
describes the location of the box in a form meaningful to the user. This parameter is
optional. Note that the entry must be surrounded by quotation marks if there are
spaces used in the text.
snmp contact="Person to contact"
This gives SNMP the value of system.sysContact, which is the name of the person
responsible for managing the PortServer. This parameter is optional. Note that the
entry must be surrounded by quotation marks if there are spaces used in the text.
Entering snmp with no options prints out the current configuration.
Also see SNMP Protocol on page 79.