Technical data

PortServer Terminal Server Page 63
send
Syntax: send telnet_special_character
This command transmits one of the following telnet special characters to the last active telnet
session:
ao abort output
ayt are you there?
brk break
ec erase character
el erase line
escape esc character
ga go ahead
ip interrupt process
nop no operation
synch synchronize process
For example, to send a break signal, type: send brk
status
Syntax: status
The status command displays information on the current telnet session (if any), including the
peer you are connected to, and the current mode. Here's an actual example:
#> status
Connection 1: sunny
Escape character is ^].