Instruction Manual
PSM SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 19 ⎯
* * 0: Voltage calibration, 1: OVP calibration, 2: Current calibration,
3: OCP calibration
z RS232 Interface Commands
SYSTem:LOCal
SYSTem:REMote
SYSTem:RWLock
z IEEE-488.2 Common Commands
*CLS
*ESE {enable value}
*ESE?
*ESR?
*IDN?
*OPC
*OPC?
*RCL {0|1|2|…..|99}
*RST
*SAV {0|1|2|…..|99}
*SRE {enable value}
*SRE?
*STB?
*TRG
*TST?
*WAI
PSM SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 20 ⎯
z Miscellaneous Commands
SYSTem:AUTO[:STATe] {OFF|ON}
SYSTem:AUTO[:STATe]?
SYSTem:AUTO:STARt {0|1|2|…..|99}
SYSTem:AUTO:STARt?
SYSTem:AUTO:CEASe {0|1|2|…..|99}
SYSTem:AUTO:CEASe?
SYSTem:AUTO:CYCLe {0*|1|2|…..|99999}
SYSTem:AUTO:CYCLe?
SYSTem:AUTO:DELay {0|1|2|…..|35999}**
SYSTem:AUTO:DELay?
* 0 : Auto, can proceed operation limitlessly (∞).
**Unit: 0.1second.