HP Scripting Toolkit 9.60 for Windows User Guide

Comment or clarificationError messageError code
The specified stripe size is invalid, or not supported by the
current RAID level, or not possible with the current
configuration.
Invalid stripe size.2844
The specified MaxBoot setting is invalid or is not possible
with the current configuration.
Invalid sectors.2845
You cannot change the MaxBoot setting on a configured
logical drive because doing so causes data loss.
Cannot change logical drive sectors.2846
The specified array accelerator setting is invalid or is not
supported by the current configuration.
Invalid array accelerator setting.2847
You cannot change the array accelerator setting for the
current controller configuration.
Cannot change logical drive array
accelerator setting.
2848
—Invalid ClearConfigurationWithDataLoss
parameter.
2849
—Controller does not support RAID Array ID.2850
The scripted RAID Array ID is invalid. Use characters from
the set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +, :, ., /, and
Invalid RAID Array ID.2851
[space]. The ID cannot end with a space character or exceed
the maximum number of characters allowed by the controller.
—Invalid SSP state.2852
—Cannot change SSP settings.2853
—Invalid SSP adapter ID.2854
—Controller does not support logical drive
SSP states. Use the SSPState controller
command to set the controller SSP state.
2855
—Controller does not support controller SSP
state. Use the LogicalDriveSSPState logical
2856
drive command to set SSP states for each
logical drive.
—Invalid surface scan delay.2857
The controller is not redundant or does not support
redundancy settings.
Controller does not support redundancy
settings.
2861
The specified value for the preferred path mode is not valid,
or the controller is not available.
Invalid preferred path mode.2864
The specified preferred path is not a valid chassis slot for an
available active controller, or the controller is not available.
Invalid preferred path.2865
—Failure opening capture file <text>.2866
—Failure opening input file <text>.2867
—Failure opening error file <text>.2868
The <text> command is missing or in the wrong place in the
script file.
<text> command expected.2869
—<text> is not a supported command.2870
The <text> command does not belong in the Controller section
of the script file.
<text> is not a Controller command.2871
The <text> command does not belong in the Array section
of the script file.
<text> is not an Array command.2872
44 Scripting Toolkit utilities