Command Reference Guide

2.9 NAME 57

• PoolName

The name of the FSE media pool to add new medium to.

• –r, – –remove

Remove an existing FSE medium from the FSE system. This is possible

if all FSE medium volumes on the medium are empty. Note that unless

additional option – –force is speciﬁed, the command demands FSE admin-

istrator’s conﬁrmation before performing this operation. Default answer to

the conﬁrmation question is "No"

• –l, – –list

If this option is used alone it list barcodes and status information of the FSE

media that is conﬁgured within the FSE installation. If additional argument

Barcode with the ––volume option is given then it shows the status of all

medium volumes on medium with the speciﬁed barcode. If the argument

combination – –list – –volume is used then the status of all medium volumes

on all conﬁgured FSE media is displayed. Reported status information for

an FSE medium includes:

1. medium barcode,

2. medium type (AIT–1, AIT–2, AIT–3, SAIT–1, LTO 1, LTO 2, LTO 3,

DISK, UNKNOWN),

3. name of FSE media pool the medium belongs to,

4. current status of the medium (uninitialized, free, open, in use, full,

unreliable, unusable),

5. current location of the medium in an FSE library slot (library name

and slot number) or in an FSE drive (drive name),

6. number of volumes on the medium,

7. index of system volume (value 0 is displayed if it is not present).

Status information for an FSE medium volume includes:

1. name of the corresponding FSE medium,

2. index of the volume on medium,

3. medium volume type (data, system),

File System Extender 3.2 Command Line Reference