Server Management Guide

Scenarios and Best Practices
Intel
®
Server Boards and Server Platforms Server Management Guide 103
Property
Task
SysIdentification
This R/W property reflects the current state of system identification.
It can set to any of the following values:
System identification can be turned off as follows:
->Set SysIdentification=OFF
System identification can be timed ON as follows:
->Set SysIdentification=TIMED
Set the timeout value. The TimeOutValue property is set to TIMED and
SysIdentification property value is set to ON.
Note: If set SysIdentification=INDEFINITE, then TimeOutValue property is set to
INDEFENITE and SysIdentification property value is set to ON.
TimeOutValue
This value is R/W, which is associated with TIMED (ON) gives input in seconds as
follows:
INDEFINITE - System identification is ON for an indefinite period.
TIMED –System identification is ON for only a known period.
OFF- System identification is currently OFF.
If TimeOutValue is TIMED then set the TimeOutValue to
->Set TimeOutValue=3 (only numeric, non-zero values accepted).
Identity
This read only property gives a brief explanation of the present target and cannot be
changed.
5.7.4.2 Supported Verbs
The supported verbs of the system1 target are as follows:
Verb
Is used to
cd
Change from one valid target path to any other valid target path.
exit
Exit from the current SMASH* session.
help
Provide information on using SMASH*.
set
Set the R/W supported properties.
reset
Reset the R/W supported properties
show
Show all the targets, properties, and verbs supported by this target.
start
Start the device.
stop
Stop the device.
version
Show the current version of SMASH*.