Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 26 of 119

Figure 11: Spring-Loaded Pin and Crank Handle and Carriage Lock Bar

9. From the back of the lift, insert a wheelie bar into the back of the leg tube with the holes in the

wheelie bar facing up, as shown in Figure 12.

Figure 12: Wheelie Bars (at Right)

10. Push the wheelie bar in until it touches the spring-loaded pin.

11. Pull the spring-loaded pin just enough so the wheelie bar can move forward into the leg without

allowing the leg itself to move.

12. Once the wheelie bar has moved forward slightly, release the spring-loaded pin and push the wheelie

bar further into the leg until the pin snaps into the first captivation hole on the wheelie bar.

13. Repeat for the other wheelie bar.

14. Repeat steps 1 to 12 for the second Genie Lift.