Instruction Manual

MicroShockDetector plus
- 22 -
• Shock magn. x, y, z:
minimal amplitude of the acceleration (storage criterion) can
be set and activated separately for each axis
• Shock strength:
minimal “area under the curve of the resulting space vector”,
additional storage criterion that can be activated
• Shock duration:
minimal duration of the event (storage criterion, for detailed
explanation see Principle of the shock recording in section
4.3.6)
Alarm thresholds:
• Shock alarm x, y, z:
Acceleration value from which an alarm is displayed; can be
set and activated separately for each axis
• Temperature
upper/lower:
Upon exceedance/falling below, an alarm is created
• Humidity upper/lower:
Upon exceedance/falling below, an alarm is created
• Pressure upper/lower:
Upon exceedance/falling below, an alarm is created
• Light upper/lower:
Upon exceedance/falling below, an alarm is created
4 . 3 . 3 S y s t e m e v e n t s :
The system events show events that concern the status and the operating behaviour of the device.
Possible errors in the hardware are also recorded. The display field for system events is normally
hidden and can be shown by activating the option “Extended diagnosis” in the menu „Settings“.
The corresponding view then opens in the lower screen area. The events can be scrolled with the
bar.
The following system events can occur:
• Turned on/off:
The device was turned on or off
• 24H interval:
24 h of operating time of the device are expired
• Device configured:
the device had been configured.
• Channels configured:
limit values/thresholds were activated/changed
• Time synchronised:
the system time of the device had been configured
• USB (dis)connected:
the event was caused by activities via the USB interface