Instruction Manual

MicroShockDetector plus
- 39 -
5 . 3 C O N F I G U R A T I O N M O N I L O G
®
C O N N E C T
The app settings can be opened using the button .
Note:
The settings menu is only accessible if the app has been opened using the “READ DATA +
SETTINGS” button after successfully entering the password.
5 . 3 . 1 P a s s w o r d
Allows changing the password. To change the password, the previous password must first be
entered. The new password must be 2 to 8 characters long and can consist of numbers, letters and
special characters. In general, the app can be used without using the password. Should sensitive
information such as the stored email addresses be accessed or changed, the app must be opened
via the “READ DATA + SETTINGS” button after successfully entering the password.
5 . 3 . 2 E m a i l
Allows changing the email configuration. Email addresses can be added, deleted or changed. Up
to six email addresses can be stored in the app. The first email address must always be entered.
This is required to reset the configuration password. By setting the “check mark” to the right of the
email address, you can select whether a read-out device status report should be sent to the
associated email address. At least one “check mark” must be set. The configuration is saved using
the “SAVE” button. Valid email addresses must be entered, the app does not validate them.
5 . 3 . 3 F u r t h e r
Allows further configurations of the app. The output language of the status report can be set here.
You can choose between German, English and Chinese (simplified). The status report is sent to all
selected email addresses stored in the app in the language set here.