User's Manual

6
1.7. Disposal
Refer to this user manual and to manuals related to other parts of the N-Com system in order to
disassemble the system from the helmet. Once the system has been disassembled, dispose of it
according to the following instructions:
 The presence of a crossed-out wheelie bin indicates that in the European Union the
product is subject to separate collection at the end of its useful life (European
Directive 2002/96/EC).
 Do not dispose of these products together with undifferentiated urban waste.
 The proper disposal of obsolete equipment contributes to preventing possible negative
consequences on people’s health and on the environment.
 For more detailed information on the disposal of obsolete equipment, contact your municipality, a
waste disposal service or the store where the product was purchased.
2. INSTALLATION
2.1. Positioning the speakers and the microphone
 Remove the adhesive film from the Velcro of the speakers;
 Position the speakers so that they stick perfectly to the cheek pad.
N.B.: If possible, position the speakers underneath the comfort padding of the helmet.
The microphone can be fixed onto the helmet in two ways:
Boom Microphone:
 Place the section with the Velcro/adhesive strip between the padding and the rigid cover of
the helmet, so that the microphone is correctly positioned in front of your mouth.
N.B.: This type of microphone is suited for Open Faced and Flip Front helmets.
Caution: make sure that the side of the microphone support with the writing “N-Com” is facing inward.
Wired microphone
 Using the Velcro/adhesive strip, place the microphone inside the helmet in front of your mouth.
N.B.: This type of microphone is more suited for Full Faced helmets.
 Connect the microphone with its counterpart on the wire assembly
 Extract the e-box connector from the backside of the helmet, ready to be connected with the e-
box
2.2. E-box installation
The e-box must be placed on the back side of the helmet, using the adhesive feet
 Clean the helmet surface where the adhesive feet will be positioned.
 Connect the connector to the e-box
 Insert the adhesive feet on the device and verify the correct positioning of the e-box on the
helmet. If necessary, depending from the shape of the helmet, substitute one or more
adhesive feet with high type until you find the best combination in order to assure the correct
adhesion of the ebox.
 Remove the protective film from the feet and apply the system to the helmet;
N.B.: In case the adhesive plate is not in the right position, peel it off immediately from the
helmet and repeat the positioning.