User Guide

Setting Up 61
Storage Management Services Administration Guide
103-000134-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Changing Your Target
Any time you are performing a series of backup or restore sessions, you might
need to change your target. This can be easily done from the SBCON Main
Menu either at the command line or from the Windows workstation using
NWBACK32.
If you do not specify a new target, SBCON automatically selects the target
used during the last session and continues without asking you to make a
selection.
 Ensure that you have met the prerequisites detailed in “Prerequisites for
SBCON Tasks” on page 81.
 Load the required TSA. (See “Loading the Target Service Agents” on
page 45.)
Changing a Target at a Server
1 Select Main Menu > Change Target to Back Up From or Restore To.
2 Select one server.
3 From the list of Target Service Agents, select a target.
If the target you select includes more than one TSA loaded, SBCON will
show you a list of their full names.
4 Enter the username and password for the target you just selected.
The target is successfully changed.
Changing a Target at a Workstation
1 Run NWBACK32.
See “Loading NWBACK32” on page 47.
2 At the Quick Access window, click Backup.
You can use the toolbar to open this window if preferred.
3 Double-click What to Backup.
4 Double-click Workstations (or NetWare Servers).
5 Select the workstation (or server) to use as the target.
The target is successfully changed.