Installation and Programming Guide

Information Displayed When Programming
The LCD will display the following data with the Function Switch in the
SET PROGRAMS position, in conjunction with the following dial settings.
Valve Run Times - Shows minutes (e.g. 15 MIN) or hour (e.g. 1.5
HOUR). Also displays OFF for unused valves.
Start Times - Displays time in AM, PM or OFF for unused start times.
Skip Days - Shows days numbered 1–15, or OFF. The words, ONCE
EVERY appear to the left.
Schedule - Displays ON or OFF. If Skip Days has been set, three
dashes (–) and the words SKIP MODE will be displayed for each of
the seven daily settings.
Today - Displays seven individual days for a weekly schedule, or
displays day interval numbers (1–15) for a Skip Days schedule.
Information Displayed During Operation
With the Function Switch in the RUN position and the dial set to
CURRENT TIME, the currently operating valve number will be
displayed.
Automatic Mode with No Program ON - With the Function Switch
in the RUN position, the current time with a flashing colon (:) is
displayed. If the entire display is flashing, the controller has just been
plugged in or there has been a power outage. If the colon is not
flashing, the controller is using battery power.
Automatic or Semi-Auto Mode With Program ON - Displays the
current time. Turn the dial to an active valve and the display will show
the valve number, the program (A, B or C) and the time remaining for
that valve to run. If you turn the dial to a valve that is not currently on,
the display shows OFF (even though that valve may have a
programmed run time).
Manual Mode - With the dial pointing to the appropriate valve, the
display shows the valve’s number, an M (for manual), and the time
remaining for the valve to run.
Short / Malfunction Detection - A flashing OFF indicates that the
dial is pointing to a valve that has a short or other electrical
malfunction.
Note: After a power outage or when the controller is energized, the display will flash
12:00 PM (or the current time if it was a short outage). Stop the flashing by pressing
either of the +/- Buttons.
10
What the LCD Display Indicate