Network Router User Manual
2.1.3. Establishing Connection
Once the IP connection (WiFi or Ethernet) is setup, power up the GRouter device. It takes about
60 seconds for the GRouter device to boot up. Boot-up has completed when the yellow User LEDs
start ashing. To verify that the IP connection has been made send an IP ping to the GRouter
device default IP host address (10.0.2.40). In Linux, Windows 2k+, or Mac OS X a ping can be
sent from the command line as follows:
ping 10.0.2.40
en type enter or return.
If there is no response double check all network connections and cables. Once you can
successfully ping the GRouter device, establish a web connection from a web browser window as
follows:
http://10.0.2.40
en type enter or return.
e GRouter device web interface will prompt for a user name and password. e default user
name is Adept and the default password is Gadget. e user name and password are case sensitive
so make sure to use a capital A and capital G respectively. Click OK. You will now be shown the
home or status page for the GRouter device web based Conguration Tool. To navigate the
various pages in the Tool, simply click the buttons on the le side of the page to link to the
appropriate page. e button corresponding to the page that is currently displayed will be
highlighted in pink. Each of the pages in the web based Conguration Tool will be explained in
the following sections.
Fig.2.7: User Name and Password Authentication
Once communications have been established, new IP or WiFi parameters may be entered. e
procedure is as follows:
• Set up IP and/or WiFi interface between host computer and GRouter device using default
network settings
• Recongure the GRouter device to use new network settings
• Recongure the IP and or WiFi network to use new settings
-27-