Network Router User Manual

• On router A’s Twin Mode Setup Page, enable Twin Mode by selecting the associated ON radio
button. e routers will now act as a redundant pair.
• Go to the Twin Status Page to observe operational state and failure statistics.
• e monitoring application on each router is now ready to be commissioned. Repeat the
following steps for each router.
• Drag a new device shape onto the LonMaker drawing. e device should be attached to the
channel on the LON side of the GRouter device. Setup and commission this device. Use the
SRV App to send a service pin for the monitoring application.
• Drag a new functional block onto the lonmaker drawing and associate it with the newly
created device. e status and alarming network variables are now ready to be bound.
e sequence of dialog boxes you will encounter is given below.
Fig.3.7: LonMaker New Device Dialog
-68-