Technical data

Setup
312185S 9
System Start-up
When initially loading the fluids through the system,
leave the mixer off until both fluids flow freely from the
nose piece without any air. This prevents cross contami-
nation from having fluid on one side pushing back up the
other side.
Mixer Selection
Disposable mixers are available from 3/16 in. I.D. to 1/2
in. I.D. in lengths from 12 elements to 36 elements. In
general, wide viscosity or mix ratios require more mix
elements. Small I.D. mixers produce lower flow, higher
back-pressure, and waste little material. Large I.D. mix-
ers produce higher flow, lower back-pressure, and fewer
lead-lag ratio errors. Different mixers can have differing
snuff-back characteristics.
Setting the Amount of
Snuff-back
NOTE: For Models 255179 and 255181 only
The MD2 valves with hard seats use two snuff-back
restrictor rings (13) to set the amount of snuff-back.
These two rings are trapped between the main valve
body and the nose piece. When the fluid valve pulls
back to close, it enters the restrictions, stops flow, and
pulls the fluid back until the needle reaches its carbide
seat.
Maximum snuff-back results when both restrictors are
used. Some snuff-back is still achieved without the
restrictors because of the pull-back action of the nee-
dles.
When dispensing wide mix ratios, it is best to use a
snuff-back restrictor only on the high volume side. This
keeps the high volume side from being pulled back into
the low volume side.
The MD2 valves with soft seats have an adjustable
snuff-back. Turn the knob on the back of the soft seat
MD2 valve to adjust the amount of snuff-back.
In general, use only as much snuff-back as necessary to
give a good cut-off of flow. Too much snuff-back pulls an
air bubble into the mixer. This can cause a drip, or cause
the mixer to spit when the valve is re-opened.