User guide

Troubleshooting
13. Power up the servers attached to the RA4000.
The fault LED on the front panel of the RA4000 should now be green,
indicating a fully functioning system.
1. Remove the Fibre Channel cable 1 attached to the GBIC in the failed
RA4000 Controller.
2. Squeeze the tabs on either side of the GBIC 2, then remove the GBIC
by pulling it straight out of the RA4000 Controller 3.
2
2
3
1
Figure 4-15. Removing the Fibre Channel cable and GBIC
3. Squeeze the latches 1 and pivot open the two ejector levers 2 securing
the RA4000 Controller.