HP VPN Firewall Appliances Network Management Configuration Guide

760

RIPng configuration examples

Configuring RIPng basic functions

Network requirements

As shown in Figure 390, all devices learn IPv6 routing information through RIPng. Configure Router A to

filter the route (3::/64) learned from Router B, which means the route is not added to the routing table of

Router A, and Router B does not forward it to Firewall.

Figure 390 Network diagram

Configuration procedure

1. Configure the IPv6 address for each interface. (Details not shown.)

2. Configure basic RIPng functions:

# Configure Firewall.

<Firewall> system-view

[Firewall] ripng 1

[Firewall-ripng-1] quit

[Firewall] interface gigabitethernet 0/1

[Firewall-GigabitEthernet0/1] ripng 1 enable

[Firewall-GigabitEthernet0/1] quit

[Firewall] interface gigabitethernet 0/2

[Firewall-GigabitEthernet0/2] ripng 1 enable

[Firewall-GigabitEthernet0/2] quit

# Configure Router A.

<RouterA> system-view

[RouterA] ripng 1

[RouterA-ripng-1] quit

[RouterA] interface gigabitethernet 0/1

[RouterA-GigabitEthernet0/1] ripng 1 enable

[RouterA-GigabitEthernet0/1] quit

[RouterA] interface gigabitethernet 0/2

[RouterA-GigabitEthernet0/2] ripng 1 enable

[RouterA-GigabitEthernet0/2] quit

# Configure Router B.

<RouterB> system-view

[RouterB] ripng 1

[RouterB-ripng-1] quit

[RouterB] interface gigabitethernet 0/1