Using the HP DTC Manager/UX

Using the Rear Panel Conﬁguration screen

Entering values in the board and port fields

This section explains what you should enter in the Board and Port ﬁelds of the

Rear Panel Conﬁguration screen.

Configuring Global Parameters (not specific to a given port)

1 Enter the appropriate value in the board field as follows:

DTC 16TN: L or l, for the LAN board. The LAN board is factory

installed on a DTC 16TN.

DTC 16: C or c, for the CPULAN board.

DTC 48: C or c, for the CPU/LAN board.

DTC 72MX: The number corresponding to the LAN board. The LAN

board can be in any slot but is usually in slot 0. You can

specify the LAN board using L, l, or the number of the

board.

2 Press the Action Menu (F5) key.

3 Choose the menu item corresponding to the DTC parameter you want to change.

Use the following information to conﬁgure the DTC global parameters.

Configuring port parameters

Note You cannot go to the port field of the Rear Panel Configuration screen if you specify

C, c, L or l in the board field.

1 Specify the number of the board where the port you want to configure is located.

Valid values are:

DTC 16TN: B or b speciﬁes the 16 ports of a DTC 16TN. A DTC 16TN has

no separate boards, but is often referred to as having one board of

16 ports and a LAN board.

DTC 16: 0 or 1.

DTC 48: 0 through 5.

DTC 72MX: 0 through 3.