User Manual

3
during the programming process. (Refer to the vehicle owner’s manual for location of radio, remote
start, and amp fuses.)
• Unplug all accessories from cigarette lighter or any other auxiliary power port on the vehicle
BEFORE programming (cell phone chargers, GPS, etc.)
• Disconnect any mobile devices from the entertainment system BEFORE programming (Bluetooth,
USB chargers, smart phones, etc.)
• Daytime running lights should be disabled before programming. See vehicle owner’s manual for
information on how to turn off.
After inspection of the vehicle and removal of the fuse(s) that operate any accessory packages, continue with
the installation of the programmer.
Once the programmer cable has been connected to the vehicle’s diagnostic port and to the programmer, DO
NOT remove or disturb the cable during the ENTIRE programming process. Only remove the cable from the
diagnostic port when the installation is complete.
DO NOT leave the vehicle unattended during programming. The programmer screen will display instructions
for you to follow i.e., turning the key to the On position (but NOT starting the engine), and you will be asked to
select certain engine tuning and vehicle adjustment features.
During the installation and programming if an error should occur, an error code and/or message will be
displayed on the programmer screen, along with a phone number. Write down the error code or message and
contact the Hypertech tech support department on the provided telephone number from 8am-5pm, Central Time,
Monday-Friday. Have the part number and serial number off of the programmer, and your vehicle’s VIN #
ready when you call.
Most programming errors are caused by electrical interruptions. Please see Section 3 with more information for
troubleshooting programming problems.
SECTION 1: PROGRAMMING INSTRUCTIONS
Set the parking brake. Connect one (1) end of the provided cable to the programmer.
Locate the diagnostic port under the driver’s side of the dash. Plug the programmer cable into the diagnostic
port.