Multifunction Printer User Guide

Overview of Network Setup and Configuration

Phaser® 8510/8560MFP Multifunction Product

2-2

Overview of Network Setup and Configuration

To set up and configure the network:

1. Turn on the system and the computer.

2. Connect the system to the network using the recommended hardware and cables.

3. Configure the system’s network address, which is required to identify the system on the

network.

■ Windows operating systems: Run the Installer on the Software and Documentation

CD-ROM to automatically set the system’s IP address if the system is connected to an

established TCP/IP network. You can also manually set the printer’s IP address on the

control panel. Once the IP address is set, continue the installation procedure to install

the driver software.

■ Macintosh systems: Manually set the system’s network address (for TCP/IP) on the

control panel. Install the driver software on the computer from the Software and

Documentation CD-ROM.

Note: For information on driver installation, see the section in this chapter for the specific

operating system you are using.

If the Software and Documentation CD-ROM is not available, you can download the latest

driver from www.xerox.com/drivers