Setup guide
Table Of Contents
Chapter 9: Mackie Control 37
Ableton Live
Before proceeding, you must already have completed the steps described in “Setting Up EuCon for Mackie Control” on page 35.
To finish the configuration:
1 Choose Live->Preferences.
The Preferences dialog opens.
2 Click the MIDI tab on the left.
3 Select Mackie Control or Mackie Control Classic from the Control Surface column. We recommend Mackie Control.
4 Select the desired MIDI emulation ports from the Input and Output columns for the Mackie Control Surface.
5 Repeat steps 3 and 5 for each additional Artist media controller in your network.
The MIDI ports selected here should match those specified in the Euphonix Preferences Pane.
6 Close the Preferences dialog.
Your Artist media controller should now be controlling your application. If not:
• Make sure Live is the front-most application (i.e., the one receiving keystrokes and mouse clicks). The Artist media control-
lers control only the front-most application.
• Check that all steps in “Setting Up EuCon for Mackie Control” on page 35 and in this section have been performed correctly,
and reboot your Mac.
• Make sure the Euphonix MIDI device in Applications->Utilities->Audio MIDI Setup is blue (active) and not gray (inactive).
If inactive, select it, click Remove Device, and click Rescan MIDI.
Live MIDI Preferences dialog