Programming instructions

Section 6 — Effect Parameters
Edit/Effects Parameters 5
PHASE DEPTH Range: 0 to 99
This parameter controls the depth of the notches created by the phasing.
ROM-08 FLANGER+REV
The FLANGER+REV algorithm is similar to the Chorus+Reverb algorithm with a single LFO.
Assign a voice to BUS1 to get the flanger plus reverb, and use BUS2 for reverb only. BUS3 is dry.
BUS1 REVERB MIX Range: 0 to 99
This parameter controls the Dry/Wet mix of the Flanger into the Reverb.
BUS2 REVERB MIX Range: 0 to 99
This parameter controls the Dry/Wet mix of the Reverb for signals sent to BUS2.
REVERB DECAY TIME HI FREQ BANDWIDTH
LOW FREQ DECAY REVERB DETUNE RATE
DIFFUSION REVERB DETUNE AMT
HI FREQ DAMPING
See the descriptions under HALL REVERB.
EARLY RFLECTION LEV
See the description under Chorus+Reverb.
FLANGE CENTER Range: 0 to 99
This parameter controls the center of the flanger width.
FLANGE RATE Range: 0 to 99
This parameter controls the rate of modulation of the flanger effect.
FLANGE WIDTH Range: 0 to 99
This parameter controls the range of the high to low frequency sweep in the flanger effect.
FLANGE FEEDBACK Range: -99 to +99
This parameter controls the amount of feedback applied to the flanger. The sign of the value
determines the polarity of the feedback.
FLANGE DEPTH Range: 0 to 99
This parameter controls the depth of the notches created by the flanging effect.
ROM-09 ROT. SPKR+REV
A rotating speaker simulation with reverb and distortion. Assign a voice to BUS1 to get both
rotary speaker with distortion and reverb, and use BUS2 for reverb only. BUS3 is a dry bus (no
effect). There are selections on the Variations screen for the Rotary Speaker without Distortion.
BUS1 REV AFTER ROTO Range: 0 to 99
This parameter controls the Dry/Wet reverb mix of the Rotary Speaker.
BUS2 REVERB MIX Range: 0 to 99
This parameter controls the Dry/Wet mix of the Reverb from signals sent to BUS2.