Programming instructions

Section 6 — Effect Parameters
Edit/Effects Parameters 7
BUS1 REV AFTER CHOR REVERB DETUNE RATE/AMT
BUS2 REVERB MIX CHORUS RATE/AMT
REVERB DECAY TIME CHORUS MIX
LOW FREQ DECAY CHORUS FEEDBACK
HI FREQ DAMPING
See the descriptions under Chorus+Reverb.
BUS3 DDL MIX Range: 0 to 99
The BUS3 DDL Mix determines the Dry/Wet mix of the Digital Delay.
DDL TIME L/R Range: 0 to 1500
This parameter determines the delay time for the left and right channels independently. It is
adjustable from 0 to 1500 in 1 millisecond increments.
DDL FEEDBACK Range: 0 to 99
The DDL Feedback parameter controls the amount of feedback applied to the Digital Delay.
ROM-11 CMP+DIST+REV
A screaming guitar-and-amp simulator that features not only compression, distortion, and
reverb, but flanging and EQ as well. BUS1 routes the signal through each of these effect
processors, while BUS2 is used for reverb only. BUS3 is dry.
Comp
L
R
BUS2
Main
Outputs
EQ
CMP+DIST+REV Signal Routing
DistortFlange
BUS1
Reverb to Compressor Feedback
BUS3
Reverb
Bus1
Bus2
BUS1 REV AFTER DIST Range: 0 to 99
This parameter controls the Dry/Wet mix of the Distortion.
BUS2 REVERB MIX HI FREQ DAMPING
REVERB DECAY TIME
See the descriptions under HALL REVERB.
COMPRESSOR THRESHLD Range: 0 to 99
This parameter controls the threshold level for the compressor. As the input signal dies away
below the threshold, the compressor will increase the gain of the system, causing feedback to
increase as well. Normal compression is “72.”