OSI/FTAM Programming Reference Manual

NonStop FTAM Initiator Error Messages
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
B-26
FTAM Initiator Error Codes
-6008
Cause. You called FTM_READ_REQ_ or FTM_ERASE_REQ_ after opening the file
with a processing mode that did not include the read or erase actions, respectively.
Subcodes. To determine what processing mode was required, see Table B-10 on
page B-24.
Effect. The initiator rejects your request.
Recovery. Close the file and reopen it specifying the correct processing mode. If the
processing mode required is inconsistent with the access requested when the file was
selected, then deselect the file and reselect it with the requested access that supports
the required processing mode.
-6009
Cause. On the FTM_READ_REQ_ procedure, you specified an access context that
was not supported or inconsistent with the document type being accessed.
Subcodes. None.
Effect. The initiator rejects your request.
Recovery. Retry the request using a valid access context selected from Table B-11.
For an explanation of access context, see the OSI/FTAM Programming Guide.
-6010
Cause. The data-value parameter of the FTM_DATA_REQ_ procedure was
incorrectly specified.
Subcodes. The error subcodes listed in Table B-12 on page B-27 indicate how you
could have improperly specified the data-value parameter.
ZFTM-ERR-PROC-MODE-NOT-AVAIL
ZFTM-ERR-ACCESS-CNTXT-INVALID
Table B-11. Access Contexts by Document Type
Document Type Access Context
FTAM-2 FA, UA
FTAM-1, FTAM-2, FTAM-3, and NBS-9 UA
ZFTM-ERR-INVALID-DATA