Instruction Manual

MicroShockDetector plus
- 30 -
Erase memory:
The function “Erase memory” deletes all data in the device.
Attention!
Make sure that you have completely read out the data before deleting it and
saved it as a *.msd file! Deleted data cannot be restored!
Configure password and access rights:
It is possible to protect the device with up to four passwords each exhibiting different access rights.
Each password can contain up to 8 characters. A new password can be created by clicking the
“Add password” button. The new password setting is saved in the device by clicking on the
“Transmit password” button. A password can protect an arbitrary number of different access rights.
E.g. if you protect the configuration of your device through a set password, you will be asked to
enter the corresponding password at the first configuration attempt during this session. After
successfully entering the password, configuration and all additional access rights, protected by this
password, are unlocked for the current session. A session persists for as long as the device is
connected to the computer and the Software MONILOG
®
Analyzer is opened.
Note:
To remove a password again, click on . The deletion must be confirmed by successfully entering
the password to be deleted. If you have forgotten the password, please follow the
instructions in section 4.3.9 Service information on the device to request a reset password.
Figure 22: Configure password Figure 23: Access protection display & delete
password