User's Manual

BX5
13
N.B.: BEFORE replacing the left polystyrene cheek pad, follow the instructions provided in the following
chapter.
3.7. Installing the adhesive keyboard
Fig. 27
 Remove the N-
Com plug from the left side of the
helmet; to make this easier, it is recommended to
push the plug from t
he inside of the helmet. (Fig.
27)

Thoroughly clean the outside surface of the shell
to make sure that the adhesive keyboard sticks
properly. Before you apply the keyboard, make
sure that the shell area is completely clean and
grease or dirt free.
Only for Jet helmets or flip-up helmets : Carry out the operation with the chin guard open.
Fig. 28 Fig. 29
 Bring the antenna outside the helmet, passing it through the hole in the shell (Fig.28)
 Pass the Flex cable of the keyboard through the hole in the outer shell. (Fig. 29)
Fig. 30
Fig. 31
 Insert the antenna into the groove on the plastic support of the keypad (Fig. 30).
 Push the antenna until you hear a click (Fig. 31).