User's Manual

9. AUDIO DEVICES WITH CABLE CONNECTION

N-Com B1 allows connection via cable (sold separately) to audio sources equipped with the

3.5mm output generally used by these devices for the headsets.

To listen to the audio source, connect the cable to the helmet using the micro-USB port,

then start playing the audio file on the device, then activate the audio peripheral device

using the specific key.

You can turn on or off listening in the helmet by pressing the “” key for 2 seconds.

N.B. : You cannot stay connected in intercom mode with the pillion passenger while using

the audio source via cable.

10. RIDER-PASSENGER INTERCOM MODE

In order to use B1 in wireless intercom mode, both helmets have to be equipped with a N-

Com Bluetooth system.

In order for two N-Com systems to communicate with one another, they have to be paired

up first.

10.1. Intercom affiliation

1. Make sure both N-Com Bluetooth systems are turned off;

2. Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more than

4 seconds), until the LEDS start to flash quickly;

3. On either one of the two helmets, press “on” briefly;

4. After a few seconds, the helmets “recognize” each another, a beep is emitted to signal

the pair up was successful and intercom communication is activated;

5. Turn off both N-Com Bluetooth systems and turn them back on to store the pair up

data.

10.2. Intercom function

To activate the intercom connection, turn on the two N-Com systems and briefly press

“on” on one of the helmets.

Intercom activation With B1 turned on, briefly press “on”.

Intercom deactivation With B1 turned on, briefly press “on”.